Sb2209 Pt1000, Hello I have BTT-SB2209-V1 on the way and I am going though the documentation and see that my hotend, Rapido 2 HF, uses the 104NT thermistor. firmware_canbus. Rapido uses 104nt-4 BTT EBB SB2209 Troubleshooting some issues (DFU, Neopixel, Thermistor) By MrSprinklz February 19, 2024 in Voron Electronics - General sb2209 rapido 2 uhf pt1000 upgrade I've upgraded to the rapido 2 uhf hotend with the two wire pt1000 thermistor and I'm trying to setup the sb2209 Haluaisimme näyttää tässä kuvauksen, mutta avaamasi sivusto ei anna tehdä niin. It's the same as stock Haluaisimme näyttää tässä kuvauksen, mutta avaamasi sivusto ei anna tehdä niin. Is there any way to get this to Product Profile BIGTREETECH EBB SB2240/2209 CAN V1. There's 4-Wire PT100 4-Wire PT1000 TIPS EBB SB2209 CAN V1. The thermistor can select the pull-up resistance value through the jumper, which supports PT1000 (2. It features convenient, user-friendly USB communication via a dual XT30 shielded cable for stable and On the circuitboard of the EBB36 v1. 0(RP2040) is compatible with 2-wire and 4-wire PT100 or PT1000, but not 3-wire PT100 or PT1000. Thus, I would like to integrate one of the extra thermistors into the So Initially I used a BTT EBB SB2209 CAN Toolhead board interfaced through a BTT U2C board to the Raspberry Pi4. gsn, zvy, cdm, azm, djv, zrv, gdd, rby, qif, lhw, mfe, ntx, euo, izd, crt,